Help Needed with engine removal

[rx7boy]

I\'m looking for some help with taking my engine out of one car and into another, have got quite far but just need a little advice on what to do next, Im in Egham if anybody is willing to come round just to help by pointing out a few things or answering a few questions that would be great !!

thanks

[Aceman]

I\'ve helped take a few out, but always in the style of "mark this here and replace in the order removed" rather than "I know what I\'m doing and understand this"..

If you simply need a hand from someone who\'s removed an engine or two before, then I\'m not too far if you want a hand, but answering questions on hows and whys is not a strong point to me

[Ricco_04]

I did mine recently for the first time ever and the biggest pain was probably me! :spank

Best thing is, if you are unsure of something in particular then post it up and see what advice you get.  I had to do the same and everyone was really helpfull :yes

[hairyhoover]

is yours a single turbo conversion?

[hairyhoover]

this may or may not be any help... but this was the list i made when i took mine out - its a single turbo conversion:
throttle
oil cooler feed centre engine to driver side rad... bango bolt
oil feed to passenger side rad, push fitting with clip
fuel return....towards passenger side
fuel feed...towards middle
p/s banjo bolt on top
p/s push fitting hose...
2 bolts for starter motor
4/5 bolts round g/box longer one goes in towards the bottom for starter motor
brake servo vacuum hose
rad feed + return
intercooler piping
ast back in place bolt in sub frame
battery tray 3 allen bolts in the subframe
battary
heater matrix  feed goes in near main water return
bottom heat matrix hose to feed under inlet elbow
wastegate vacuum hose
vband clamp to dp
weird vacuum hose near fuel line push fit under intake elbow
oil pressure switch
6 bolts for fly wheel cover
screamer pipe to waste gate small vband
****************ecu....4 clips on ecu**********************
blue clip
white clip
earth bolt
4/clips straight to ecu yellow
***************enginebay wiring none ecu*************************
main altnertor feed / start motor feed
altnertor clip(2 thin wires)
water level sensor = black/red - brown/white blue

engine earth
sensor from sump blue clip to red clip

[BlitzBoy]

Darren you forgot
Dodgy eBay wastegate in the Bin :rollin

[hairyhoover]

haha, it fell to bits inside!! .. once i fixed i was getting 0.8bar as expected.
 
so it seems to be ok. But i still fancy a new Tial one.