Urgent help alternator problems

Started by GaseJo, May 13, 2008, 09:09:02 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

GaseJo

Hi all,

My alternator is not charging my battery. I have had the casing powdercoated so i ground back where the tensioner is and earthed it from there. Is this ok for earthing the alternator? the plug connector is cliped in place and the large wire is bolted on tight so i think these parts are ok.
Any help appreciated.

Cheers Garith.

cyman

if all the original cabling is connected if you want to check to see if the alternator is earthing well use a voltmeter continuity test touch one prob to the the alternator body and the other to the earth terminal on the battery. you can also do a resistance check this way to see whether you have a bad earth.
 
i take it you have actually checked at the battery when the car is running that it isnt charging ie volt check battery with engine not running around 12v then start the engine check the voltage again it should be around 14v then turn on your interior fan and put the headlights on and you should see very little drop under load. if the voltage drops down to 13v or so then the alternator has issues.
 
hope this helps
 
si

shaunwil

I had the same issue and in the end got a local alternator repair shop fix it. The casing is a grounding point for the board too. I need to swap cases over so I\'ll post some images of what they removed to get it going again.

Shaun
1994 White FD with A-spec GT3574R - 358bhp at the hubs at 0.9bar :3gears-lh
2003 Mondeo 2lt 130ps Diesel Estate Daily :driving

GaseJo

Thanks shanwil that will be a great help.

Cheers Garith.

shaunwil

1994 White FD with A-spec GT3574R - 358bhp at the hubs at 0.9bar :3gears-lh
2003 Mondeo 2lt 130ps Diesel Estate Daily :driving

GaseJo

Thanks mate,

I will strip mine down later and clean off all them bits.

Cheers Garith.

GaseJo

Thanks for all the info Guys especially shaunwil.

Just stripped the alternator cleaned of the powder coating on all them places. Put it all back together and she is puring again.

12.4v engine not running.
14.5v engine running.
14.3v with lights & fan on.

Cheers Garith.

shaunwil

Great to hear. Good news then :D

Shaun
1994 White FD with A-spec GT3574R - 358bhp at the hubs at 0.9bar :3gears-lh
2003 Mondeo 2lt 130ps Diesel Estate Daily :driving