main engine loom

[hairyhoover]

Hi, i am trying to work out which plug goes to switch sensor the the engine. It has a single turbo conversion so it should be straight forward enough - i hope. Unforunalty i didnt see how the loom came off the engine so i wasnt in a position to lable it up. Do you know where i might be able to find a labled up diagram/ picture. Ive tried searching here and also RX7club.com but with no luck.
 
Are the sensors below the only ones i need to use on a single turbo conversion?
 
2 x primary injectors
2 x secondary injectors
throttle position sensor
air temp
water level
water temp
theres another water sensor (round - not to sure what its for)
idle control vavle rear of UIM
oil meter pump
oil pressure switch
2 x crank angle sensors
 
is there anything else?
 
cheers

[shaunwil]

Have you got the proper workshop manual. Think theres a detailed section on engine electrics. Do a search for it, I think the link is in a sticky.

Shaun

[hairyhoover]

hi, ive seen the below manual, its on page 36 but it doesnt show much is this the one you were talking about?
 
http://www.rx7city.com/Manuals/93%20Manual/3_ENGINE.pdf