Header intake........

[shaunwil]

Im finally getting closer with my exhaust but i\'ve come up against a stumbling block. In the intake i have the two middle intakes and a 3rd port underneath it. From reading on rx7clud they say its an exhaust port ? Do i need to seal it off with a blanking sandwich plate on the intake Not sure if it was covered before :confused:

Cheers

Shaun

[mpk490p]

you do need to blank this off, sure pip at WGT will be able to help
Mark

[shaunwil]

Will chat to pip again tommorrow about it, he got a gasket to me quickly but i think i\'ll get some 2mm stainless cutout for it tommorrow. Will need another gasket for it anyway !

Shaun

[shaunwil]

I\'ve had a couple of 2mm blanking plates cutout and i\'ve sandwiched it with gasket paper keeping the original gasket between the engine and the first plate. Will hopefully have the car back in one peice by the end of the weekend to see if its made a good enough seal !

If anybody wants the dxf file for it then just ask !

Shaun