fitting a c\'s short shift

[COUNTZERO1978]

Hi all just purchased a c\'s short shift & have no instructions & would like some help with fitting it if poss??,any info would be greatly appreciated!.

[Jit]

hmmm....i got one of these at home but i cant remember how it comes apart either lol! If you take apart the stock shifter gubbins, should it not be obvious (im not digging at you...im serious )

[Jit]

OK my shifter has the following components...the best thing is to start by making sure you got everything

The shifter unit itself..this has a small yellowish bearing type thing on the ball at the bottom. It also has a rubber boot just under the metal. It has finally got a wide plastic bit which says "C\'s" on one corner...this is the big bit with 3 holes.

Then you should have 3 bolts and washers with allan heads

Youd should have something which is made from metal which resembles a spacer with 3 bolt holes

And finally a plastic washer type thingy which sits inside the thing i mentioned above...