Messages

Hi
Would you sell the lenses seperate for the Mazda GTC bumper?

Sold

Sure would do just the injectors for 400.

Ok, finally sorted it.

Firstly, sorted the leak out on the secondary rail by installing in the original rubber o rings into the intake manifold.
Lastly, found out the standard primary injectors were stuck closed (some that I purchased to take out my ID ones)....changed them over for a spare set and fired right up.

Cheers for the help guys.

Yeah it was idling fine then soon as any gas it cut out.
Both primary injector electrical plugs were showing to run fine and now with them in the secondaries the car is starting and idling but just hunting. When I got it started this time it only started to hunt when she got warm so was able to trace the leak. I'll try these new seals when I get them and if still having issues will take out the primaries and get them cleaned.

[£480]

Injector Dynamic 2x ID2000cc & 2x ID850cc Injectors and KG Rails

My FD is going back to standard so letting these go. They are practically brand new and have only done around 50 miles of use. Worked perfect, these are considered as the leading injectors for any car. Also selling with the KG rails and connections as per the picture.
These cost me last year $920 for set of four injectors not including the shipping & tax charges.

£480

[/URL][/img]

[/URL][/img]

[/URL][/img]

ok, so put new plugs in and new leads....same thing not starting or even catching. Tried with some easy start and she started firing but still no start.

Anyway, I plugged out the electrical plugs to all the injectors and only connected up the secondaries using the primary connectors. She fired right up, and started to hunt. Traced a loud hissing leak to the secondary injectors where the injector goes into the manifold, so ordered some new seals. For reference the part number for these are NF01-13-257A (Lower Secondary Fuel Injector Grommet). They should be here in a few days so hopefully will resolve the issue.

Just a quick question, would this vac leak actually prevent the car from starting?

Ok, ordered some new plugs today to try out and give a go with some easy start see if it does the trick. Its cranking at 200rpm with the new starter.

Can someone confirm if there PFC sensors "PIM, VTA1, VTA2" highlight when there cranking over?

Seems bit strange that these drop to 0.0v when cranking.

Would be hard to tow as quite low 
How about easy-start spray? When you say blow torch, u mean to heat them up....would new plugs be best bet?

Thanks for the advice guys. Yeah done the full de-flood........plugs out, loas of mist until cleared. Plugs were soaking wet with fuel, cleaned and dried them, put them in..............still nothing, not even an attempt to start.

The car started fine, ran out of fuel outside the house(was stood for a while) then after lots of attempts to start, burned the starter motor.
So changed for a new starter motor, she started up straight away and would only idle, any gas and would cut out.

Now she not starting at all. At first it tried to start, now it just doesn't even attempt too.

I've done the following;

1) Cleaned plugs. They kept getting soaking wet of fuel after cranking so changed injectors to standard rails (were aftermarket before). Now seem to be normal with little fuel but still no attempt to start.
2) Checked injector wiring (lightbulb test) and operating ok.
3) Fuel pressure when cranking is 42psi
4) Have spark.
5) No fuel leaks.
6) cant see any boost leaks (very few vacuum lines as single turbo)
7)Not done compression check, but when plugs out have even, loud swoosh noises.

When cranking PFC shows 8 & 0 degrees for IGN.

I've also noticed that when cranking over,in the PFC Sensor screen the PIM, VTA 1, VTA2 highlight and voltage shows 0.00V. This is only when cranking, when the key is just in the on position they are not highlighted and show correct voltage. Is this normal?

Anyone have any ides what to try next?

Hi mate, can you send some pics to amirs@hotmail.co.uk

Can you email me on
amirs@hotmail.co.uk

Interested if the price is right

Hi mate

Is this still for sale? If so ill take it.