Messages

Yeah probably. The design has obviously changed since.

Looking at the picture, my headers are a lot shorter. More of a mid-tube rather than long tube.

I have Hinson headers and y-pipe. My RH header doesn\'t fit as it touches the frame rail. I have had to cut the flange off so that I can reposition the header and get it welded again. Also, the flange is warped so it leaks. Not the best quality. TBH I would go custom if its not too pricey.

I will be going to this (not with my car). I live in fleet so it\'s easy

Went last year but I am hoping for a bigger turn out this year. Especially with the weather.

What model and condition are the Teins?

I bought some from the states last month. Got stung about £20 for customs. Shipping was only $5 though.

http://www.speedbleeder.com/size.htm

Sb7100 and sb8100 I believe. (FD)

Haha. Good choice

Did you manage to check the pins? I am after the drivers side caliper.

Gutted. I feel for you.

Sorry guys came back with full intentions of doing all this but made the fatal mistake of taking my car for a geometry set up. Couldn\'t do it because the lower rear arm cam but had seized but did the toe only 58 minutes out on all 4 wheels.

Then I tried to repair my handle. Needless to say didnt work


Anyway the lights,
Look a bit cheap, as I said 2 pin connector on the back which is the bulb and single red wire with bullet connector coming out. I\'m guessing power of some sort.
Comes with a black base plate I\'m guessing that they mount too.

Will get some decent photos tomorrow.
Will try the brakes tomorrow too, will just put some pressure on the calliper pistons if they move they\'re good enough Is that right

Could you just check to see if the brake pad pins come out? on my current ones one of those pins has fused to the caliper.

Don\'t think you will be able to test the pistons without reconnecting them all. Unless you blow them out with a compressor.

I will take the calipers if they are still available. This is assuming you can post?

Could you just check to see if the brake pad pond move freely?

mdwoz (at) hotmail dot com

I know people will say "I control traction with my pedal foot" but surely this has to be a time when traction control may have helped?

Threads like this give me the fear.

I basically take the price including delivery then add 32% plus £8. Pretty much gets you to the correct figure.

I dont think there is a threshold for secondhand parts. You pay duty on anything over £14 IIRC

You got a pair of steering rack clamps (but with the nuts still attached).