Messages

Hi

Sure this may have been seen before.

http://www.youtube.com/watch?v=dCEMqs4zg9A


Shows how unstable the car becomes at speed and under braking, when a spoiler is removed. (at end of clip)

Thanks for your reply. Thats helped alot.

bump............

bump.............

Hi all

I have a stock port FD3S which im toying with fitting a single turbo too.
I know the T04E is good for stock ports but what is the T61 like.
Could someone tell me as what rpm both these turbos will see pos boost and also full boost based on the .ar being correct.

Cheers

lol   :Thumbs-up

Cheers for the replies guys. I will try looking at this from the used or new kits route.

:cheers

i guess no ones ever had to buy any parts to convert their FD to a single turbo

Hi

Could you guys who are running single turbos point in the right direction of where to buy all the parts i need (including turbo) for a T04E setup. Fuel and cooling side not required.

I have a stock engined FD (no porting)

Yes the system was fully bleed. This has only started in the last few months the lines were charged over 3 years ago.

Are you able to tell me the best place to buy a new master cylinder.

Thanks for the swift relies

When i first push the break pedal it feels a little soft, on second push its hard. I have brided hoses and pads all round are near new. The brake cap does have a crack in it however.

Could anyone point me in the right direction?

Could someone tell me of a good garage near Caterham (surrey), that can fit and 4 wheel align me suspension.

Cheers

Thanks for the offer Ed. I\'ve ordered a set today.

I need a new set of shocks and want to by new. I\'ve been looking at Tein super streets and tein flex.

I\'m happy for the ride to be a little firmer and lower but not much.

Can any one point me towards one of the above. Also when there fitted does the car need seting up in any way. If so how is this done.

Could anyone who owns a ARC induction box tell how do you connect the pipe form the air pump to the induction box?

:cheers