Messages

the coils are labled t1 L1/2 t2. on the housing it has L and T. L is the bottem T is the top. the leading is wasted spark so has two leads going to it. i do advise drawing things before taking them off for the first time

does any one know what the pilot bearing does?
seems not it is for the input shaft on the gearbox. it is not a main engine bearing so therefore does not require bedding in. if it starts fine the drive it how you feel happy, no bearings or tips have been replaced so why run it in

so lets see a power graph:) sure blitz will put his up

if the dyno temp sensor is run in one off the i/c pipes or in the engine bay, the dyno uses that reading to work out the max HP. we have the sensor measuring the room temp, we do this due to the fact that we were getting huge hp readings with sensor in the engine bay i/c pipes, as soon as we had it in the room temp we got sensible readings

where is the dyno air temp sensor positioned for your power runs?

I am sure a comapany in the south might sell them:)

//www.xs-power.co.uk

As far as i am aware the fuel pump wire is 3mm or 4mm. Does depend waht it goes through though:( Infact I know that Max\'s silver car still runs on the stock wiring.

personaly i use the proper jubilee clips. They work fine unless you have a decent ridge on the pipe, then again unless you have a decent ridge (bead) you screwed.
I work on car not language

What you welding Boss? The one you found a mate has did the welding all the welding on my exhaust manifold with no prob. Now have a snap-on one over priced but i can shove where the sun don\'t shine if it breaks:)

must get my last graph up that would put RE:Worx top three

Did someone say dyno time and Ross in the same sentence? That don\'t happen. Why do you think the hillybilly have no licence atm

have you got a touring x? it not ignore it and tuck it back where you found it just as mazda did

Pesonally i would take it to a specialist. Oh hang on i would check if all your plugs are working. And why were tyre pressures 40? I only put pressure up if i expect over 450rwhp

i do have to say it is a tad out off date my figure on the table is from a tubby I sold at least a year ago and have since sold it\'s replacment