Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Sam_w

#1
2nd generation RX-7's / Re: Air pump drive belt
July 17, 2015, 08:21:46 AM
I'm sure if I can isolate the ignition switched feed that makes them work with the sidelights that should do the trick I hope
#2
2nd generation RX-7's / Re: Air pump drive belt
July 16, 2015, 09:44:58 PM
Just checked, with the Ignition off the side lights come on with the headlights coming up, with ignition on the headlights pop up and come on dim.
#3
2nd generation RX-7's / Re: Air pump drive belt
July 16, 2015, 08:54:36 PM
I'll have to double check, I think that they do though.
I'll have to trawl through the wiring diagram and try and figure out if I can stop the signal to the headlights
#4
2nd generation RX-7's / Re: Air pump drive belt
July 16, 2015, 07:24:56 PM
Even if think that's a terrible pun (and I'm renowned for terrible puns at work!!) but with regards to the owners manual does that class the off position as its first position therefore making the sidelights second position?
#5
2nd generation RX-7's / Re: Air pump drive belt
July 16, 2015, 01:50:17 PM
Did they not do that from factory then?
Both my MX5 and S13 200SX did it but you can mod the wiring/relays to stop it
#6
2nd generation RX-7's / Re: Air pump drive belt
July 15, 2015, 10:38:00 PM
Thanks guys
Just to hijack my own thread, is there a way to stop the headlights popping up with the sidelights?
#7
2nd generation RX-7's / Re: Air pump drive belt
July 13, 2015, 09:53:14 PM
Thanks for that, got a gates belt today 900 was spot on!
#8
2nd generation RX-7's / Air pump drive belt
July 12, 2015, 04:30:11 PM
Hi guys
New to RX's and am after a new air pump drive belt.
I have a 10x950 belt but it's miles too long!
Anyone know what size to use?
Google just gives me results for air pump removal

Thanks in advance
Sam