Messages

Could you send me pics too adzn3K AT googlemail.com

You would be best posting up a spec list mate

to me they look like 300zx calipers

Also my clutch alignment tool means I can assemble the clutch off the fly and hold it all together while I fit it. I was also giving my mate an explanation on how a clutch works even telling him what happens when it\'s the wrong way lol

If the plate was the wrong way round it wouldn\'t get any gear as it would be stuck on the fly :/

I\'ve seen a braided clutch line for sale so going to get that and fit it before adjusting tthe pedal

plan of action is going to be full bleed of the master and slave then check and adjust the pedal, i dont want to adjust the pedal before i\'m sure the fluid is sorted

Cheers for the help guys.

Right followed the measurements and the disengagement height should be 48mm minimum mine is erm 2mm lol and thats if i push the tape in to the carpet lol

Cheers buddy what a fantastic link

Any links to where I can get a service manual??

It is an fd bud

The pedal travels all the way to the floor and I know there is please plenty travel on the fork as when putting the bearing back in it was a lot further back than it goes now.

The clutch I took off was a failed oem one and the new one is an exedy stage 1 so nothin too heavy I am going to re bleed it next weekend and go fork. There I think

How doo guys,

I changed my clutch last week but couldn\'t get it in to gear so left it till this weekend just gone to investigate.

What I find was the bearing wasnt being pulled very far so thought slave issues so I bled it a little and still nothing then a removed it checked it over and all seems ok so I \'re installed it got the wife to push the pedal while I looked thru the inspection panel and it was now moving a little bit more (I guess the slave wasn\'t seated right). I tried to move the car it went in to reverse and drove but would only go in 3rd.

Is there an adjuster on the clutch fork?? Or a way of seeing if the slave is sat right know the arm??

Cheers in advance guys

Adrian

no worries bud

Couple of turns with the egi fuse out and retry :

I have a stage 1 exedy ready to go on how much for just the flywheel??

I cant tow start it as the clutch has failed so will if all else fails I\'ll do it once the clutch is on

If you are up this way pop in for a brew