Title: Opening bonnet without cable wire
Post by: PETE SMITH on July 18, 2004, 12:03:28 PM
Post by: PETE SMITH on July 18, 2004, 12:03:28 PM
Hi all,
Just banding this question about as my cable release wire\'s gone and the bonnet\'s shut!
Geff-REWORX-is getting me a new one, but in case there are problems opening the bonnet, have any of you fella\'s managed to open it another way?!
Not panicking, but obv. need those regular oil/water checks done!Thanks
Pete
:wave
Just banding this question about as my cable release wire\'s gone and the bonnet\'s shut!
Geff-REWORX-is getting me a new one, but in case there are problems opening the bonnet, have any of you fella\'s managed to open it another way?!
Not panicking, but obv. need those regular oil/water checks done!Thanks
Pete
:wave
Title: Opening bonnet without cable wire
Post by: antnicuk on July 18, 2004, 09:18:21 PM
Post by: antnicuk on July 18, 2004, 09:18:21 PM
this happened to me, its a nightmare. Luckily i had a gap between my bonnet and bumper. I managed to ge a small screw driver in the gap and pop the catch. I have closed the gap so if it happens again i\'m buggered.
good luck
good luck
Title: Opening bonnet without cable wire
Post by: scooby_si on September 12, 2004, 05:46:38 PM
Post by: scooby_si on September 12, 2004, 05:46:38 PM
any joy tips or otherwise on this only mine\'s gone today & well bonnet is actually lower than bumper having reinstalled it yesterday to get cold air thing sorted, that went well but as i say i\'m now stuffed on getting the bonnet undone when & if required.
HELP
Si
HELP
Si
Title: Opening bonnet without cable wire
Post by: scooby_si on September 12, 2004, 06:28:38 PM
Post by: scooby_si on September 12, 2004, 06:28:38 PM
Right done a search on the US sites & seems there\'s a theory based upon coat hanger & prising bonnet up stuff, now i\'m not going to be able to do much with bonnet as the bumper is currently sitting slightly above it so it\'s going to be a mission at best.....
But if i can get in can anyone confirm which bit on this pikky i need to be aiming at hooking? (pikky from when front end was off so maybe slightly off where it should be but as i say just wana know which bit to try & pull in which direction incase the yanks are the other way round in anyway.....?
Ta
Si (not getting coat for once merely coat hanger
lol)
But if i can get in can anyone confirm which bit on this pikky i need to be aiming at hooking? (pikky from when front end was off so maybe slightly off where it should be but as i say just wana know which bit to try & pull in which direction incase the yanks are the other way round in anyway.....?
Ta
Si (not getting coat for once merely coat hanger
lol)