hi all,
started my engine up for the first time today after doing a diy rebuild.
it is running fine no oil or water leaks from what i can see, but after running for a while my red oil light came on.the wire that goes to the oil sump is not connected it has snapped off the sencor, there was a lot off creamy stuff on oil filler cap, but none in oil. thanks
could using the wrong oil cause the oil light to come on ie causing wrong oil pressure
i had a similair problem to this years ago when rebuilding a crossflow engine, dont have concrete proof of this but i do think that putting fully synthetic oil in was the cause
If there\'s no wire onto the pressure sensor i\'d say that\'s your problem. The sump i\'ve kept for you has a pressure sensor fitted so i\'ll leave that in at no extra cost for you as i\'m pretty much out of the rotary scene now so i won\'t be needing it :Santa
As for the oil make sure you\'ve filled with mineral oil especially if you\'ve gone to the trouble of rebuilding it!
Dave.
thanks all, drained oil tonight and put 10_40 in it ,same thing light was flicking on turned it off played with the wire to the pressure sensor started it up and no light came on so all good. and thanks dave still need the sump so will sort payment for you m8