i have a GReddy Profec B II.... to install to a single turbo FD.
the system is a simple turbo and external waste gate setup.
the waste gate has two outlets the side vent connected to UIM.
top vent sealed.
the screw spring on the waste gate is protruding over 1cm
where do i connect the two vac hoses from the boost solenoid?
I wouldn\'t run the bottom/side to the UIM, its a bit more responsive fitting it as close to the turbo as possible.
"T" of that hose and connect to NC on solenoid(the only one you can\'t blow down).
Connect a hose from COM on solenoid to top of wastegate.
The top vent shouldn\'t have been sealed.
Phil