got this kit just to see how it looks, was only a few quid... but dosent look like it will fit... any ideas
(http://i667.photobucket.com/albums/vv38/daview82/419977_2958574330616_1449253791_32857262_1938899404_n.jpg)
it\'d be a bad idea to remove the fuse entirely, find the wires going into that section of the fuse box, splice the kit in, and you should be ok, but it\'d help to see the entire kit.
the kit is just those 2 connectors in the pic... runnind down to a normal 20a fuse, then running onto a switch for inside the car, not much to it... was thinking because the kit is fused i could just change the connectors to female?? wats ur views
This is how it fits:
http://www.club323f.com/?page_id=781
thats it... the rest is just the wire
(http://i667.photobucket.com/albums/vv38/daview82/426222_2958731134536_1449253791_32857296_366798275_n.jpg)
Follow the guide from club323f its the same kit as they are using for the BG :)
dosent look the same kit... unless they made a wire them selves to go with the kit
supose i could chop 1 wire to copy the 323 1
You might need to just change 1 of the end spade connectors - the 323F fuses are the normal mini blade sort rather than the larger fuses, I would also check if theres not an internal fuse for the headlights rather than the massive 30A retractor fuse!
i think u missing a wire. a short one with a male spade at one end and a female spade at the other.
part 6 of the 323 link mitch gave. the bottom pic, there is a short red wire. u need that also.
You could always just take the retractor fuse out and manually wind the headlights up :rollin