Iv got a choice at the moment for my rebuild,
I have 8 oil control rings in the house that i will need to measure to see if they are in tollerance as apparently they are quite hard wearing,
Well this is my choice would you use ones that are in tolerance or pay about £200 ish for a new set?
Has anyone got experience with using old oil control rings?
Cheers
Kris
I used old ones, they were well within tolerance.
I was under the impression everyone used old ones, though I suppose if you were using new plates and housings and money burning a hole in your pocket you could buy new ones:)
I also thought they cost a lot more than £200
sweet old ones it is, what are the tolerance levels?
anyone know them off the top of there head?
Kris