Text only | Text with Images

Mazda Rotary Club

General => General Technical => Anything Engine/Performance/Tuning related => Topic started by: MintyFresh on June 30, 2004, 11:49:17 PM

Title: how much bhp increase with simple mods?
Post by: MintyFresh on June 30, 2004, 11:49:17 PM
If someone was to add this to a standard FD:-

Apexi Power FC
Upgraded Pump and Injectors
Intercooler
Induction Kit
Boost Controller

what bhp and boost could u run safely?


thanks
Title: how much bhp increase with simple mods?
Post by: yonner on June 30, 2004, 11:52:09 PM
i aint an expert but i think with 0.9 bar??? or psi???? u can hit about 300 hp if not a bit more ass i say i aint an expert i jsut remember sum1 talkin about that b4ps use the pfc boost controler its suposted to be good and can be controled via the commander
Title: how much bhp increase with simple mods?
Post by: GaryS on June 30, 2004, 11:56:45 PM
I\'ve got a similar setup (FMIC) and at just under 14 PSI I got 279.5 rwHP at CPL.
Title: how much bhp increase with simple mods?
Post by: FDDreamer on July 03, 2004, 03:11:10 PM
Does the fuelling system need to be uprated with such mods? I read somewhere that it\'s critical to get the car re-mapped or upgrade the ECU when doing even basic mods as it can cause a large boost spike and possible detonation.

Anyway, if the fuelling was left standard, but a new downpipe and and full exhaust system were added what would the difference in power be if the boost level was left standard?

Errr...could i have said that in a more confusing way?!?! :confused:

2nd go: What power would a stock (\'96, 265bhp) FD be with:

Apexi Power FC
Full exhaust system, downpipe all the way to back box
Induction Kit
FMIC

:rolleyes:
Text only | Text with Images