In the later spec pin out diagram ( 96 on ) it shows the omp stepper motor labelled as motors 1-4 . If you look at the earlier spec loom data it just shows 4i to 4l labelled as omp stepper motor , now would this mean I could just put these terminals in any slot of the new ecu pins which say omp stepper motor?
I looked at the earlier spec manual and it confuses me with the explanation ;
4i ignition switch on B+
4j 3terminals/
4k 4 terminals
4l B+
other terminal 5-9v
need to suss out so i can pop in the aprporiate pin on the power fc
Any input appreciated , apart from stupid noob:Laugh
If you can email me your phone number I will send pics and take meter readings tomorrow as I have a harness attached to an engine in my kitchen.
(Oh yeah, the wife loves me)
you my dear friend are nothing short of amazing ! thanks so much for your help, im no electrician and its a bit of a struggle for me, im getting better with this area and your help is really appreciated. ill email u right after i have helped my sister out
have emailed you , hope using your i.m details was the right way to do things?
did you recieve my email Phil? not trying to pester , just thought id ask if you recieved it - plus i was curious if the wife has thrown a wobbler yet for having an engine in the kitchen :-)