Anyone have the data sheets for what the engine tolerances should be for fc block?
Preferably a mazda tech sheet or similar.
(thanks in advance prof :p im assuming you have it hiding somewhere in your aladins cave of knowledge :))
Hey Liam, have a look at this site should have the info you require.
Cheers
Link http://www.rotaryheads.com/PDF/2nd_gen/ still half asleep
Quote from: L18M;781759(thanks in advance prof :p im assuming you have it hiding somewhere in your aladins cave of knowledge :))
Festa beat me to it :)
There\'s a lot of measuring - and you\'ll want some good Micrometers or calipers for measuring the eshaft and bearings - tricky to centre a measuring tool for the ID on the bearings.. If you\'re in doubt, a local engineering firm should be able to assist, but you\'ll only need to check and measure the eshaft for tolerance - as you\'ll be replacing all the bearings I guess.
You\'ll need a surface plate anda magnetically mounted DTI for a lot of it.
Prof that reminds me - I\'ve found some of my scans, I\'ll do you a copy :)
Quote from: Brett;781798Prof that reminds me - I\'ve found some of my scans, I\'ll do you a copy :)
Are you pregnant Brett? :Giggle
:rollin
Quote from: Brett;781798Prof that reminds me - I\'ve found some of my scans, I\'ll do you a copy :)
Ta Chief :):Thumbs-up
Cheers guys, much appreciated :) will check out the link.
Lmao ben! :)