is this possible?
suddenly fancy some of these on the fc, cherry blossoms, originals not fake rota poo
(http://a5.sphotos.ak.fbcdn.net/hphotos-ak-ash4/185616_139141442817617_103474616384300_241378_2765657_n.jpg)
Some of the series 4 cars had 4 bolt hubs - think that was about the same pcd as the 5 bolt - so probably would fit.
Not entirely convinced I like them - they are a bit yes/no/yes/no :D
A proper engineering shop would be able to re drill your hubs and then you suppliy new studs. Job done:Thumbsup!
I agree with Mr Kiwi, the 4 stud FC setup was designed with the poxy little brakes of the poverty spec US FC in mind :)
They\'re cool, but could be more work that you probably want to fit them!
However if you do, might take your wheels off you for a grinder price :D
Those wheels are butters!!
Quote from: Jit;774051Those wheels are butters!!
Excuse my ignorance but WTF does \'butters\' mean? :rollin
id suggest getting adaptors but that would require spacing those wheels out and they look like they have a rediculous offset. What about re drilling the wheels?
Do the hubs on the FC swap with something like the MX-3 which had a 4 stud pattern?
Would solve your problem if they did - plus my sis has an MX-3 so that could end up with the 5 studs!! ;)
good idea kiwi :Thumbsup!
dtheb: they wont need spacers, if anything need wider arches! they not the low dish rota jobs lol
cant re-drill wheels as not much to drill lol
ricco: hmm.. interesting idea. would take a while to save up and buy the cherryblossoms though. not cheap! cost more than my car! though bit worried i might see my car on bricks pretty quick if i did get them :Hammer
Quote from: L18M;774101though bit worried i might see my car on bricks pretty quick if i did get them :Hammer
Maybe its better to get the Rota copies then? Cheaper, direct fit and no worries about them being Pikey\'d!
(There is nothing wrong with rota rims either ;))
mx3 / 323(f) are all 4 x 100 pcd sadly!
Butters = lush or \'but ugly\'....depends! :)
i like \'em...
GLWTS conversion / fitting, keep us posted ;)
Sakura\'s are awesome! Hideously rare/expensive though. Do they even do them in 17"?
Quote from: fil_auto;774113mx3 / 323(f) are all 4 x 100 pcd sadly!
Ahhhh, never even considered that bit - only thought of the studs, doh! :Typing
Quote from: papercutout;774155Sakura\'s are awesome! Hideously rare/expensive though. Do they even do them in 17"?
nt seen 17\'s, would be amazing if they did lol
16"?
Anything less than 16" on an FC = mega, MEGA lows, and Sakura\'s need to be run on slammed cars.
yep a US S4 EFI has 4 x 114 hubs i got some over to convert to bigger discs and callipers, presume the rear set up can be interchanged too
Quote from: mpk490p;774550yep a US S4 EFI has 4 x 114 hubs i got some over to convert to bigger discs and callipers, presume the rear set up can be interchanged too
(http://t0.gstatic.com/images?q=tbn:ANd9GcTM38pgNwuC-Kzrc7TbnQAWAG9-I7IIl8xstKM7tO_K3YP3agVu)