I\'m just gathering bits together for the non-sequential conversion and the guide on the rotary resurrection site says you need vacuum caps in the following sizes: 5/32”, 1/4”, and 3/8” (approx 4mm, 6mm, and 10mm)
Does anyone know roughly how many of each size are needed?
Thanks!
Not sure man but there\'s a good few. I capped mine a different way. I got a solid rubber hose, as in no hole. Then cut a bit off and a quick drill later an I have the the size I need for a nice tight fit. I couldn\'t get rubber caps for the life of me so it was my only answer.
But for all I\'m sure they cost, just get plenty. Like 10 plus of each. Will need more of the smaller ones from memoy anyway.
The solid hose is a nice idea!
I managed to find quite a few places that sell silicone caps, but most have large minimum order quantities. The best i\'ve found so far is a minimum order quantity of 100. It\'s only like a £5er for the smaller sizes, but for the big ones it\'s £26 for 100! Might just have to bite the bullet, and try to flog on what I have left over...
Well if ya want man, I\'ll see if I can get my hands in some more of that solid stuff and send it to ya?