Print Page - offset question

Title: offset question
Post by: Kenji on March 23, 2011, 01:38:51 PM

I have two sets of wheels which I want to spacer out a bit.

18x8 ET40 front, 18x9 ET46 rear.
Will they fit a stock arched FD with 15mm spacers?

Other set is same size, Et35 all round.
Same question. Will they fit with 15mm spacers?

Title: offset question
Post by: SiH on March 23, 2011, 02:10:38 PM

What tyre sizes?

Title: offset question
Post by: Kenji on March 23, 2011, 04:04:21 PM

225-40-18 front
235-45-18 rears

Title: offset question
Post by: fil_auto on March 23, 2011, 05:03:16 PM

this might help you out! to show offset difference / widths etc.... - i reckon you\'ll be alright with what you have TBH ;)

http://www.willtheyfit.com/

Title: offset question
Post by: SiH on March 23, 2011, 06:10:31 PM

Gonna be close, depends on alignment - fronts will scrub the liners on lock, and probably on hard hits.
Rears again, may be very close, but I think they\'ll start shaving the edges.
Light roll of the rear arch lip, and a bit of bending and zip tying on the front and you should be ok.

Mazda Rotary Club

Cars by Model Type => 3rd generation RX-7's => Topic started by: Kenji on March 23, 2011, 01:38:51 PM