Print Page - Microtech LT-8....I need some plugs.

Title: Microtech LT-8....I need some plugs.
Post by: captainbizzaro on February 20, 2011, 06:28:04 PM

So I\'ve bought a Microtech LT-8 and hand controller for my conversion but it only has the main centre plug with it. I\'ve emailed Microtech direct but does anyone have any experience with this issue? Can you get the plugs seperately as I\'d have thought this is quite a common situation when swapping ECU\'s between various cars.

Any thoughts?

Title: Microtech LT-8....I need some plugs.
Post by: 12at on February 21, 2011, 10:20:59 AM

what centre plug you talking about??

the loom plug or the handset cable / plug?

Title: Microtech LT-8....I need some plugs.
Post by: captainbizzaro on February 21, 2011, 10:30:37 AM

The loom plugs, I only have one of them.

Title: Microtech LT-8....I need some plugs.
Post by: 12at on February 21, 2011, 01:37:09 PM

The microtech loom is not terminated. it only comes with the plug that goes into the ecu.. you just use the standard plugs on your water temp sensor, air temp and injectors.

Title: Microtech LT-8....I need some plugs.
Post by: captainbizzaro on February 21, 2011, 10:40:44 PM

Yeah I know that, it\'s the multi pin block plug at the ECU end I need. I can buy a set direct from Microtech for $45 Aus and a complete loom for $165 but want to know if I can source one in UK first.

Title: Microtech LT-8....I need some plugs.
Post by: 12at on February 22, 2011, 09:32:32 AM

best to get a complete loom from jon at microtech or better still buy my lt10s & x4 box that comes with a terminated loom :)

Mazda Rotary Club

General => General Technical => Anything Engine/Performance/Tuning related => Topic started by: captainbizzaro on February 20, 2011, 06:28:04 PM