Hi am having Problems finding RPM signal for s4 fc, the ECU is N322 the right hand plug is smaller than that on any pin out i have seen it has got 14 pins 2 unused, any help would be great
thanks jim :2Confused
I didn\'t say it was the egi n/a , I need to fit a safc to hopefully get it past its MOT
Thanks Jim
could maybe get a signal off the ignition driver ?
What mods are you running to give the emmision probs?
Hi air pump removed, cat removed and air filter, I have got over 7% co and 2000 ppm hc and just need to get it down for the MOT, can I take off of the wire that goes from the coil to the rev counter I think it yellow with blue on the diagram ?
thanks Jim
Quote from: lennycarloff;737771Hi air pump removed, cat removed and air filter, I have got over 7% co and 2000 ppm hc and just need to get it down for the MOT, can I take off of the wire that goes from the coil to the rev counter I think it yellow with blue on the diagram ?
thanks Jim
Depends how well the input of your fuel computer is - signal wise that will have what you need, but the voltage spikes on that line may be quite large - check the manual for the fuel computer - make sure it can take a signal from there (could be upto 400v spikes on the coil primary).
Your best bet is to install an air bleed valve on the lower inlet manifold, and thecadjyst the preset on the AFM, this will lean it out enough for an MOT.