ive got a little screw that has become super rusty and the head of it has been degraded somewhat but it can fit a screwdriver in it but impossible to turn. what do people do to loosen these screws? regards !
david: //www.kagoshimaenglish.com/rx4.htm
IMPACT DRIVER FTW!
(http://lh3.ggpht.com/_48YrRheBLxs/RryKq8HbAJI/AAAAAAAAENg/MteUYAofFwg/DSC_3883.JPG)
^^this :D
Impact drivers are the way forward (or anti-clockwise if you see what I did there....)
thanks for your help, ill try heating it up, a bang with a hammer, and see how i go !
No, an impact driver is not a posh worcd for a hammer! It\'s a screwdriver that when smashed witha hammer, both screws (or unscrews) and applis pressure -a bout 20 quid, and hugely useful :cool:
Until you take all the screws off and replace them with cap head stainless :o
drimmel cut a slot in it then grab a flat blad screw driver and undo it
or drill the fecker out :)