Hi folks,
Bought some Swoosh gauges for my car (oil temp and pressure), each gauge has a 5 wire power feed.
The instructions say :
Wiring for ALL SAGA gauges :
RED - Battery +
BLACK - Ground
BROWN - connect into sidelights or dimmer switch, this is to lower the gauge illumination at night
ORANGE & YELLOW - On the ignition switch there are normally 4 key positions as follows :
Position 1 - OFF
Position 2 - ACC connect YELLOW wire to this
Position 3 - ON here there are 2 wires, 1 will have no power when the engine is started
1 will retain power when the engine is started - connect ORANGE to this
Position 4 - START ENGINE
Im fine with everything except the Orange wire.
What the hell is the position 3 \'ON\', at first i thought it was an ignition wire, but we already have this as the Yellow wire.
Any help
Mark
i had some mate i seriously wouldnt waste your time putting them in there very acurate apparently i was running 26 psi lmao
Am I right in saying you put the orange wire on the cable from the "engine cranking" terminal therefore you maintain voltage on the gauge at all times as when it is cranking the auxillary terminal goes dead to ease the stress on the battery.
yes the orange just maintains a power feed while cranking
There ya go then Mark, hope that helps.:Thumbsup!
Awesome :D
Batman - Im sure they arent the best gauges in the world, but the last lot i had off him were within around 0.3% tolerance of a quarterly calibrated snap on gauge, so more than good enough for me. However, they used to be 3 wires not 5, else id know how to wire them!!:rollin
If the boost gauge was that far out it was faulty , hopefully you asked for your money back.
All the best and thanks folks,
mark