Hey guys,
I need to remove the rear bumper from a third generation RX-7? Can anyone tell me where the bolts are which hold the bumper on?
Cheers
LT
3 each side, One from underneath car each side, And 2x each side from the boot. You need to remove the plastic trim in the boot and the ecu , You can get your hand in and feel 2x long hexnuts each side, 12mm i think.
Quote from: TRIND-FD;7139593 each side, One from underneath car each side, And 2x each side from the boot. You need to remove the plastic trim in the boot and the ecu , You can get your hand in and feel 2x long hexnuts each side, 12mm i think.
And the rear lights come off to expose the fixings across the top. remove the number plate aswell, And then give it a good pull.
Got some pics when I took mine off:
(http://sphotos.ak.fbcdn.net/hphotos-ak-snc4/hs401.snc4/46391_427371132962_503322962_5187880_681497_n.jpg)
Can see the three bolt holes at the side, along with where it fixes along to top edge.
You\'ll be left with this:
(http://sphotos.ak.fbcdn.net/hphotos-ak-ash2/hs159.ash2/41293_427371202962_503322962_5187881_5166866_n.jpg)
Hope that helps. :) Little hint too, once you\'ve taken the fixing screws out, the lights SLIDE sideways off the car. Took me a while to figure out lol.
You guys are awesome, thanks very much.
Off to the garage I go...
Good luck. Don\'t drop the nuts inside the wing when you remove them ;)
Top thread, just what i needed to read/see thanks guys! :Giggle