hi i have a Polished Manifold LIM for rex but there or pips on it and there is no pips on my rx7
(http://i238.photobucket.com/albums/ff309/gavinnblake/ghj.jpg)
this is my engen its an 1996 Maxda RX-7 Type R Single Turbo T88
(http://i238.photobucket.com/albums/ff309/gavinnblake/Now%20my%20third%20car%20rx7%20580BHP/Rx7%20engen/Rx7%20engen%20blow%20on%2023may2009/Geting%20rebuilt%20at%20jm%20imports/2009-11-04140321.jpg)
will it be ok
they are vacuume nipples just blank them off with nipple caps(sits back and waits for the jokes)
Nio need to blank them or do anything with them.... if you have no hoses (sorry pips) attached on the inner side then just leave them as is.
Or just cut them off and make them flat like your original one.........
Can the Mazda RX7 FD3S Polished Manifold LIM (http://cgi.ebay.co.uk/Mazda-RX7-FD3S-Polished-Manifold-LIM-/220601160002?cmd=ViewItem&pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item335cda9142) fit on all model if not how can you tell & on theMazda RX7 FD3S Polished Plenum UIM (http://cgi.ebay.co.uk/Mazda-RX7-FD3S-Polished-Plenum-UIM-/220601155721?cmd=ViewItem&pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item335cda8089)as my rx7 is an 1996 Type R Single Turbo.
Was going to get WGT to fit the Plenum UIM. He said it was for a newer model then my rx7.
How can you tell ?
These will fit any FD engine O/K
They don\'t route into the LIM. If you look they actually pass straight through between the runners. Just leave them open :)