Hi all.
Have recently completed changing my heater matrix after a lot of swearing and cut fingers, now i have been told that it would be a good thing to bleed the water system before proceeding can anyone tell me how i can do this.
Cheers:3Confused
You need to bleed the air out to the highest point of the engine.
If you look at the back of the engine there is a pipe that comes from the end plate and goes to the throttlebody.
Remove that and put a pipe on the throttle body side and lift them up, run up the engine until water starts to flow nicely out of the top of the pipe without air.
Keep squeezing the silicon pipes to ensure water is being pumped through.