hi all
my old air temerature sensor used to read 129 on my power fc, so fitted a new riat one but my pwer fc still reads 129 all the time.
is this right could some one tell me what theres is reading plz
its a 92 fd thanks :Thumbs-up
Mine would be lucky to reach 30\'C at this time of year.
In the commander go into ETC, Sensor/SW Check, then tell us the voltage at the AirT.
hi mate it reads 0.14v
Mine reads round about 3.0v. When my old sensor went faulty it read -40\'C and was just below 5V.
Try disconnecting the sensor I think it should read 5V, if its still 0.14 then I would say you could have a short or dodgy PFC.
Phil
ill try that tomorrow and thanks