Hi guys,
I recently went to get an MOT and they failed the car on the indicators going a bit mental (not their actual words), so I changed the F100 and the indicators now seem to work fine! Sadly, now the sidelights don\'t work. :Hammer
The main beams work, but the sidelights, rear lights and dash lights don\'t come on at all.
Can anyone think of what I might have done to cause this? Maybe a wire pulled loose when the F100 was changed? A fuse blown? A plug not connected properly?
I\'m going to have a go at it tomorrow morning so thought I would ask for your opinions and help this evening.
Thanks,
Mark
tns relay is gone id say..in engine bay at front
Thanks mate - will check that. It was working fine before I changed the F100 which is what I found confusing :3Confused
Hi all,
Checked the relay and that was fine but the supply to the relay was non-existant so I checked the fuses and rather strangely one of the fuses hadn\'t just blown but was completely missing!?
Anyway, I replaced it and it\'s all working fine for now. But if anyone else is in the same predicament, I found this post on the fuse layout which I found very helpful. Hopefully it will help you too.
http://www.mazdarotaryclub.net/forums/showthread.php?t=32869&highlight=fuse+box
Thanks again ad4m1 :)
Fuse my good man ;)
There is a single fuse which controles all dash lights & rear sides, but normaly the fronts are on a seperate system?? But worth checking the fuses inside the car (Drivers footwell by throttle) and under the bonnet. you could have 2 fuses blown which has caused the problems you are having ;)
Jono