I know this has been covered allot but does anyone know of someone who can replace or repair the relays in my unit?
I have a seperate unit kicking around with bad relays so i can just send it off to someone capeable to fix it.
Here you go mate:
http://fc3spro.com/TECH/HOWTO/WIPER/wiper.html
apparently this is the relay if anyone needs one.
http://search.digikey.com/scripts/DkSearch/dksus.dll?WT.z_header=search_go&lang=en&site=us&keywords=Z950-ND&x=5&y=18
Yeah i also need to do this at some point...found this rx7club saves taking the old relays out and messing with a solder sucker and ruining the board.:chat
http://www.rx7club.com/showthread.php?t=872853&highlight=wipers
iove had my relay replaced and all it does now is go flat out on II regardless of the position of the rotary switch lol
how was it done? old relay removed or second relay added?
old one removed,thwe paper connections seem good so im guessing it could be the relay itself.
Im no electrician so i may just purchase a new unit from mazda for stupid money lol
you might have damaged the circuit board removing the old relay, it might be worth getting another used wiper switch that probably wont work then try soldering the new relay on the other side of the board, sounds much easier than removing the old relay.
apparantly it doesnt take much to ruin the circuit board if the soldering iron is left on the board too long or if it\'s a too powerful iron. (low wattage soldering iron would be best)