Print Page - Injector setup ok?

Title: Injector setup ok?
Post by: m1tch on December 28, 2009, 10:47:33 PM

Hi all, quick question,

FC3S, 13B, T88, extended streetports, 550 primary, 1680 secondary

Enough fueling?

Title: Injector setup ok?
Post by: Ed_RX7 on December 28, 2009, 11:59:09 PM

yes....get an frp and a good fuel pump also......but i assume you already have these!!!

Title: Injector setup ok?
Post by: Prof on December 29, 2009, 12:05:12 AM

Have you got a compressor map for the T88 ?

Have you a horsepower goal in mind - it\'s worth having a target so that you can build everything toward that goal.

Those injectors should take you to well over 500 at the flywheel, you could go for 800cc primaries for a bit more without sacrificing too much driveability at low revs/idle.

Title: Injector setup ok?
Post by: L18M on December 29, 2009, 12:14:02 AM

worth adding a swirl pot?

Title: Injector setup ok?
Post by: m1tch on December 29, 2009, 07:45:31 AM

Quote from: Ed_RX7;661937yes....get an frp and a good fuel pump also......but i assume you already have these!!!

I have a good fuel pump and will be converting the fuel system to a parallel setup :) with aeroquip fittings :)

AN -10 fuel fittings anyone? :rollin

Mazda Rotary Club

General => General Technical => Topic started by: m1tch on December 28, 2009, 10:47:33 PM