Been working on all the elecrtical stuff on my car today. Managed to get the loom sorted out and 99% connected back up.
Just a couple of bits left over though and cant figure out where they go
1st: This one is in the engine loom near to the air con conectors
(http://i436.photobucket.com/albums/qq83/Adam-Blackshaw/Engine%20rebuild/12122009598.jpg)
2nd: This one is down the bottom under where the aircon pump used to be.
(http://i436.photobucket.com/albums/qq83/Adam-Blackshaw/Engine%20rebuild/12122009600.jpg)
And i cant for the life of me remember where this bracket is held in place :confused:
(http://i436.photobucket.com/albums/qq83/Adam-Blackshaw/Engine%20rebuild/12122009599.jpg)
Thanks
Adam
Bracket is connected to the Aluminium bracket for the pas and aircon pumps. White 2 pun looks like oil level sender on the sump (often broken off!) and the single pin looks like it connects to the coolant temp sensor under the oil pressure sensor in the rear plate
Cheers mate. Will have to have another look at the braocket then and work out where on the plate it goes.
I\'m guessing i can just tape up the 2 conectors then if ive no air con now.
Adam