hi guys got this setup which needs putting in before second mapping, was going to push the twin setup im using, only run the car once a week and am going to get it mapped again by wgt so just need to add a few mods and was hoping for some advise.
Got this plenum with two extra injectors welded in, its a wgt setup and it has a rail to feed the injectors with just a feed no return.
my question being which fuel pipe do i tap into to feed these injectors, can i just tap into the line before it feeds the primary or should i tap into the fuel line after primary but before the secondary rail or just tap in after the secondary on the return and before the fpr?.
(going to speak to wgt next week but was hoping someone may just know.
mods are decat, apexi ecu, fmic, zaust, apexi filters, currently mapped on 0.8 bar making 330fwhp
going on are bosch 044 pump, hks down pipe, and a new zaust, greedy profec b boost controller.
any advise welcome, i dont ecpect the twins to last long on 1 bar but i only do 2000-3000 miles max a year anyway and will then go single so hoping the supporting mods will sufice for my transistion inot the single world.
was hoping to go for bar and see how long it lasts :)