The heater blowers and aircon seems to have stopped working on my FD, The blowers would not come on, and when I pressed the AC button that wouldn\'t come on either (orange light didn\'t come on as well).
Obviously with the weather getting colder I am unable to defog the windscreen and it\'s ruddy freezing, I\'ve checked the fuses under the dash and all are ok, I don\'t know where to look next. Any advice/help would be appreciated. Cheers.
did this ever get fixed? This has just happened to mine.... the AC works but the interior blowers has just stopped working.... have checked all the fuses on the interior fuse box and all seem fine... does anyone know which fuse it is exactly?
Just happened to mine too, searching it out now.
im wondering if its anything like a 200sx, they have a fan resistor card, its up under the dash and its what controls the fan they have a habbit of corroding and breaking meaning you either get no fan or fan only on number 4...
however im not sure if rx7\'s have the same?
I did sort this in the end, and I feel a bit of a prat about the whole thing. When I investigated further my power connection had come unplugged from the motor, because the clip on the connector had broken. The motor is in the passenger footwell, I just plugged back in and all was sorted. Hope yours is something similar.
well i removed my motor from the pass footwell, opened it up and it was full of crud. gave it a good clean out and cleaned some of the connections and it worked again :)
got a guide on how you took yours out?
well,from memory....
Remove the passenger side trim in the footwell on the left ( 2 pop in clips and a screw in the kick sill )
unbolt the ECU and move it out the way for better acess (3 bolts)
unclip the electrical connection coming out of the \'dome\' (black connector)
there are 4 screws that hold it in, you may need to move some wires out of the way to get better access to them. 3 of the screws are pretty straight forward, the awkward one is in the far back corner, which if your quite a burley chap like me was abit of a nightmare to get undone! use a stubby phillips to get this one out.
and it should just fall out!