Print Page - Gearknob Thread Size

Title: Gearknob Thread Size
Post by: carbon on November 25, 2009, 05:41:08 PM

Hey,

Wanted to bring over my old gearknob from previous Honda, can anyone tell me what size the thread is on the FD RX7.

Cheers, Sam

Title: Gearknob Thread Size
Post by: carbon on November 26, 2009, 12:14:04 PM

Anyone?

M8, M10, M12?

Title: Gearknob Thread Size
Post by: L18M on November 26, 2009, 02:45:33 PM

its def not M8!
i think it was M10.

Title: Gearknob Thread Size
Post by: Nik da Greek on November 27, 2009, 12:20:05 AM

All I can say for sure is that it isn\'t the same as the one on a Toyota MR2 :mad:

Title: Gearknob Thread Size
Post by: carbon on December 01, 2009, 01:32:24 PM

Quote from: Nik da Greek;656553All I can say for sure is that it isn\'t the same as the one on a Toyota MR2 :mad:

What size is a Toyota MR2!

Ahh!

Title: Gearknob Thread Size
Post by: G@NDY on December 01, 2009, 02:42:45 PM

Pretty sure its M10, HTH.

Title: Gearknob Thread Size
Post by: FD3UK on December 01, 2009, 03:49:53 PM

Just checked, it\'s M10 x 1.25mm

Title: Gearknob Thread Size
Post by: Nik da Greek on December 01, 2009, 03:56:32 PM

Quote from: carbon;657306What size is a Toyota MR2!

Ahh!

M12 for future reference. It\'s just cos I bought a FEED one for the FD so I could take the GReddy one out and put it in my MR2....and it\'s a different size :Hammer Teach me to measure twice, cut once :Giggle

Title: Gearknob Thread Size
Post by: 12at on December 01, 2009, 04:29:43 PM

FC turbo is 10mm if that makes any difference :)

Mazda Rotary Club

General => General Technical => Topic started by: carbon on November 25, 2009, 05:41:08 PM