Is it possible to combine the Front Fenders of the FEED !!!!!!!!!!! Kit, with the Sideskirts of the RE-Amemiya AD-GT Kit.
As they share very similar designs, with the lower sideskirts on the FEED kit arching in more, and having a lip, as opposed to the flush curve on the RE-A kit. The difference in the arch is the raised section by the door on the RE kit, and on the FEED kit it "slides" flush into the section by the door.
Feed Front Fender & Sideskirt
(http://www.fujitaengineeringusa.com/fdimages/pl_005.jpg)
RE-Amemiya Front Fender & Sideskirt
http://www.rhdjapan.com/jdm-low/RE-Amemiya-AD-GT-Widebody-Fender-Kit-FD3S-RX-7-51189
Pictures explain it all, was just wondering if anyone had done it?
Cheers, Sam.
anything is possible but it wont be straight forward...the re wings are just half a wing and the side skirt bolt up to them, they also protrude out 2 inches or so.....
Quote from: bin liner;655401anything is possible but it wont be straight forward...the re wings are just half a wing and the side skirt bolt up to them, they also protrude out 2 inches or so.....
Yeah, like I said & picture above, are the FEED ones half a wing to though? Suppose anythings possible!
Cheers, Sam.
the feed is a full wing...
Quote from: bin liner;655855the feed is a full wing...
Cheers, have to get cutting :2Confused:eek: