After following on from:
Engine Removal Tips
http://www.mazdarotaryclub.com/forums/showthread.php?t=60137
and
Failing at Enigne Swap (Prop Shaft Woes)
http://www.mazdarotaryclub.com/forums/showthread.php?t=60363
Im now again in need of MRC assistance as a few of the wire plug connectors are lost in the engine bay and dont seem to have a partner!? :3Confused
Heres a couple pictures of the connectors that seem to have no home :-(
Tucked away near the ABS pump
(http://i5.photobucket.com/albums/y167/h20490/Photo234.jpg)
Tucked away near the Drivers headlight.
(http://i5.photobucket.com/albums/y167/h20490/Photo234.jpg)
I know people might be getting sick of me so here\'s a picture of the car in the garage its in at the moment.
(http://i5.photobucket.com/albums/y167/h20490/Photo229.jpg)
Still lots to be done as the bumper is being worked on , Bonnet will be changed , Paint needs flatting etc but its getting there.
Just found Mazdatrix too so my wallet will be empty soon with the amount of parts for the FC.
any input appreciated.
Ash
That green one - if it\'s a 3 pin connector - that\'s for setting the tps with 2 lights - it\'s not normally connected. It looks like that one - it\'s in the right place.
I think you posted up the same pic twice ;)
The one by the headlight - on the driver\'s side there is a 2 pin yellow plug - it\'s not normally connected - that one if shorted out, runs the fuel pump (it\'s for priming the fuel system / testing the fuel pump pressure) - it\'s usually on the strut tower. If there is a connector closer to the headlight - probably need a pic of it to identify.
On the passenger side - there is a 1 pin green connector and a 6 pin green connector - these are the initial set/check connector (1 pin) and the diagnostic lights connector (6 pin) where you can read fault codes off.
Cheers once again Prof!
Any ideas on these 3 connectors , one grey , one green and one white. near the drivers headlight.
(http://i5.photobucket.com/albums/y167/h20490/Photo233.jpg)
These are the last few connectors bar a few other gound connectors.
Ordering my service kit from MRP on Monday as the Yahoo Belt should come soon too :-)
Thanks for the advice!
Ash
The big one you\'ve got in your fingers (grey) is for the AFM (Air flow meter) - the white one is probably the fuel one I spoke of - it\'s normally yellow, but may have gone white. The green one is a check connector - some US/JDM models had the 1 pin check connector on that side instead of / as well as the one near the leading coil
Last question of the day I swear.
What this big pipe and wqhere does it connect to? Ive looked all over. Ive removed the Air Con and lines im sure of it but cant seem anywhere this pipe wats to connect.
Thanks again
Ash
Thanks Prof you really know your stuff!
Heres the picture I was supposed to put in the above reply.
(http://i5.photobucket.com/albums/y167/h20490/Photo235.jpg)
thats the air con pipe mate so just pull her out
Cheers the hat :-)
I will go ahead and remove that then :-)
Thanks guys one step closer to getting her fired up.
Ash
Excellent - glad to be of service...