Print Page - Reusable rotor housing?

Title: Reusable rotor housing?
Post by: Jovic82 on July 20, 2009, 10:30:37 AM

Can anyone tell me the tolerances for the chromium plating on a 13b tt rotor housing.

I have some chrome receeding from one of the edges - it is 5 inches long and receeds back from the edge 2mm. Is this to much to reuse?

Regards

Title: Reusable rotor housing?
Post by: Jim_rx7 on July 20, 2009, 02:07:22 PM

My understanding is that 2mm is the limit.

different tuners say different things. Pineapple racing say don\'t use a housing thay has ANY flaking. Mazda manual says 2mm though as far as I remember.

Title: Reusable rotor housing?
Post by: Magicmat on July 20, 2009, 02:14:55 PM

yeah im pretty sure the Bruce T video says 2mm is the limit but dont hold me to that

Title: Reusable rotor housing?
Post by: Jovic82 on July 20, 2009, 02:27:43 PM

Okay thanks guys, I will take a view on the width as it seems 2mm is close to the limit. Is there any recommendations as to the maximum length of the defect?

Title: Reusable rotor housing?
Post by: Grizzly on July 20, 2009, 04:29:35 PM

TBH i would replace if there is any defects just for longevity of the engine, I usaly fit new Housings on a rebuild where i\'m replacing the Apex\'s anyway.

Mazda Rotary Club

General => General Technical => Anything Engine/Performance/Tuning related => Topic started by: Jovic82 on July 20, 2009, 10:30:37 AM