Print Page - My Next Little Job

Title: My Next Little Job
Post by: Gman on April 21, 2004, 09:24:11 PM

I dont have a lot of air going to my induction kit, it is surrounded by a high sided tray so i think a direct route for the air is needed.

I have cut two lengths of dyson hose and will run a direct feed from the top of the intercooler to the induction kit. Nothing like a bit of DIY!!

Title: My Next Little Job
Post by: richrx on April 21, 2004, 09:47:40 PM

you silly silly person. Max Power stickers would have done that without any effort.

only joking, have you tried it yet?

rik

Title: My Next Little Job
Post by: Gman on April 21, 2004, 09:54:22 PM

Its my job for the weekend! I tried fastcar stickers to take me up to 600 bhp but they didnt work so i think i will stick to bits of old vac cleaners!!!:rollin :rollin

Title: Re: My Next Little Job
Post by: evildave on April 22, 2004, 08:05:10 AM

QuoteOriginally posted by Gman
I dont have a lot of air going to my induction kit, it is surrounded by a high sided tray so i think a direct route for the air is needed.

The tray is probably to shield any hot air from your rad upping your air intake temp. I need to get something similar for mine, on the rollers my air intake temp was 35deg- so looks like i\'ll be dismantling the hoover as well this weekend ;) :D

Title: My Next Little Job
Post by: davefrith on April 22, 2004, 09:05:29 AM

do you guys have front mounts, cos I can\'t see any way of getting piping to my induction kit with the radiator where it is ?

Title: My Next Little Job
Post by: evildave on April 22, 2004, 09:33:43 AM

i should be able to get some duct over the top of the rad, through the front bumper cavity, not sure if a standard bumper has room though, i\'ll try and post some pics after the weekend.

Title: My Next Little Job
Post by: Gman on April 22, 2004, 10:13:13 AM

I have plenty of vents in my bumper so i should be ok.

Mazda Rotary Club

General => General Technical => Topic started by: Gman on April 21, 2004, 09:24:11 PM