Hi everyone,
I\'m new on here, just thought I\'d introduce myself...
I\'m Ben, from Sevenoaks, and I\'m in the market for a 1st Gen RX-7. I\'ve always loved the FD3S, but only recently discovered the 1st gen ones, and I prefer them by miles!!
The only problem is I\'m 6\'4", and I don\'t know whether I\'ll fit! Is anyone else on here a similar height, or close by to me so I could perhaps have a sit in one? I\'m really hoping I can, I\'m not worried about fitting bucket seats or modifying seat rails if required...
Thanks in advance for any help, and hopefully see some of you out and about soon!!
Cheers,
Ben
welcome, im 6\'3 fit ok although i have to tilt the sunroof when i wear a skid lid!
Mark
Bish is quite tall as well and he has a 1st gen, dont know if he has actually sat in it yet as he is doing a major restore job with a TII turbo engine
I\'m 5\' 9" but I always have to drive with the seat modded upwards by 2" or so at the back to suit the wife who\'s quite small. I think what I\'m trying to say is that the 1st Gen might need mods for a small person but you can get plenty of tilt on the seat back for a laid-back sort of style if you\'re tall. You\'re doing the right thing by trying it first though.
Welcome!!!!!!!!!!!!!!!!!!!!!!!!!!!
Welcome to MRC Ben
Thanks for all the help guys, and welcomes...
I\'ve done a few searches and I\'ve found to look for rust under the rear wheel arches and in door bins, are there any other mechanical areas (apart from the usual brakes, suspension etc) which I should pay particular attention to when looking at cars?
Thanks again for all your help and advice guys, it\'s greatly appreciated...
Ben
i would just say remember the age of these now and be prepaired t change the bushes etc, listern for any diff noise and dont be afraid of \'wonder steer\' it is usally just a steering arm bush issue
Mark
Hi Ben & Welcome to the MRC:)
Quote from: mpk490p;601554i would just say remember the age of these now and be prepaired t change the bushes etc, listern for any diff noise and dont be afraid of \'wonder steer\' it is usally just a steering arm bush issue
Mark
Yep, working slow it takes about 30 mins to fit new steering idler bushes.
Look at the bottom of the radiator from the engine side - is the matrix \'unzipping\' - recoring the stock rad is easy but about £100.
Very few of the original exhausts left now but a new replacement one might cost £250 in M/Steel, but £500 in stainless.
Obviously does the engine seem healthy? A bit of smoke on start up is normal.
What\'s the instruments show when hot. You want a reasonably good oil pressure reading when revved - our 51,000 miler\'s oil pressure will swing upscale to about 80psi when revved hot but I think that\'s exceptional. (the engine has had 17/18 oil changes since new!).
Hi Ben
Welcome.
Rust,rust,rust!!is the most important thing to look for along with condition of paintwork.
A new reconditioned engine is approx £1200 fitted but lots of welding & a good respray £2500>£3000?
Ta...