Mazda Rotary Club

General => General Technical => Anything Engine/Performance/Tuning related => Topic started by: rx7ben on April 13, 2009, 02:59:36 PM

Title: Advice please
Post by: rx7ben on April 13, 2009, 02:59:36 PM
I have a couple of questions on my car.
 
The 1st is there is some oil coming out of the top part of the elbow pipe that conects from the intercooler to the inlet manifold. Its is leeking where the gasket is bolted in. I take it this should not be doing this ??????
 
The 2nd is when i take off the oil cap there is loads of creamy gunk like stuff down there. Im no exspert but this cant be good can it.
 
Any help on this would be good.
 
Thanks
Title: Advice please
Post by: rx jamie on April 13, 2009, 05:03:34 PM
is it ALOT of gunk or just a bit. as i had a similar problem but it was just condy.
get a comp test done to the cooling system and combustion chambers
Title: Advice please
Post by: rx7ben on April 13, 2009, 08:28:57 PM
theres alot of it
Title: Advice please
Post by: Prof on April 13, 2009, 09:30:55 PM
It sounds like one of your water seals has gone.
Title: Advice please
Post by: nuki on April 14, 2009, 11:24:50 AM
The white creamy salad cream is normal, i got worried when i saw it and could of buttered a whole loaf of bread with it... shorlty followed by my mate saying head gaskets gone...which i knew i didnt have a head gasket..anyways had it checked its quite normal on rotary engines.
Title: Advice please
Post by: rx jamie on April 14, 2009, 11:37:02 AM
not lots of it though. a little bit maybe. compression will tell all anyway.
Title: Advice please
Post by: nuki on April 14, 2009, 12:01:18 PM
yes get it tested like jamie says then you will know yourself and hopefully your mind will be put at rest :)
Title: Advice please
Post by: rx7ben on April 15, 2009, 03:36:15 PM
Had it looked and told its very normall even the rx8"s do it aparantley. As for the leeking oil i was told it cold be the oil injectors or the seals going on the turbo"s