Hello again,
below is a picture of the intake plenum on the FD, the two blue vacuum lines run from the twin BOV\'s (Bought the car like this).
What i would like to know is, are the two vacuum lines in the correct place?
Is there a difference between the lower plenum nipple and the higher nipple \'Positive vacuum etc\'?
Should I \'T\' the two BOV vacuum lines into the upper or lower nipple?
Or leave as they are?
Apologies for picture quality
(http://i70.photobucket.com/albums/i89/Dmdrifting/rx7vacuumpipesbov.jpg)Many thanks for any help! I\'ve studied the Workshop vacuum line picture briefly! Would be helpful for your advice!
The Charge Relief Valve (Sits closer to the front of the engine) Vacuum line, runs to the Lower Nipple on the intake plenum!
The Air By Pass Valve vacuum line runs to the top nipple on the plenum!
Just found a large vacuum diagram ;)
Correction the Charge Relief Valve sits closer too the bulkhead, and its vacuum line runs to the lower nipple as stated above.
The Air By Pass (BOV) vacuum line runs as stated to one of the top nipples on the plenum :Talking1