Mazda Rotary Club

Cars by Model Type => 2nd generation RX-7's => Topic started by: vonrumble on October 16, 2008, 03:46:02 PM

Title: heater/blower
Post by: vonrumble on October 16, 2008, 03:46:02 PM
How do you change the heater motor on an n/a FC? just need a rough guide.
Title: heater/blower
Post by: m1tch on October 16, 2008, 06:52:32 PM
Isn\'t it located in the passenger footwell? I seem to remember when I was running some wiring over that side, when I took the panel off (the footwell blower on the passenger side) there was a white plastic thing lol I think thats it :)
Title: heater/blower
Post by: pdtaylor18 on October 16, 2008, 07:42:28 PM
Correct, the blower is in the far left hand corner under the dash and is held in by I think 3 or 4  x 10mm nuts. Its not too bad to get at but sometimes taking the glove box out can shed more light on the whole thing but it can be done without. Take it yours is goosed or just noisey ? If you have aircon then there is also a clamp which is only a quick release and if you have not got aircon then a plastic air duct tube which again is clamped. Think at the matrix end of the duct is a little grommet, its only a push in type but needs to come out.
Title: heater/blower
Post by: vonrumble on October 22, 2008, 07:08:03 PM
totally gone, just hoping it will do the trick replacing it. checked all fuses etc nothing blown so fingers crossed, thx for the advice.
Title: heater/blower
Post by: pdtaylor18 on October 22, 2008, 08:57:51 PM
If you need a heater/blower then i have several if you need one.
Title: heater/blower
Post by: m1tch on October 22, 2008, 10:25:04 PM
im pretty sure pete can build a brand new FC out of all the bits you have in your garage/dining room/loft lol :D