Hey Guys,
I\'ve had a search around the forums, but i can\'t find a definite answer - basically i\'ve got a nice high flow cat that i\'d like to bolt on my fd3, i\'ve removed the airpump (was knackered anyway) and fitted a smaller belt.
The car is running:-
Trust SMIC
ARC Induction box
HKS downpipe
Racing Beat Catback
Knightsports ECU
If i fit this high flow cat will i blow the engine to bits?? Seems to be alot people going on about fitting an ECU before - whys this? Will it cause the engine to run very lean?
I\'m going to get a apexi next month, but am i ok to run with this setup for now?
Cheers
Clive
Heres a pic of the ol\' weapon....B)
(http://i12.photobucket.com/albums/a213/Twin40/16082008358.jpg)
Potential to run lean and lose a tip with those mods. Drive off boost until you get the apexi fitted.
Oooooo I like the rims mate.... what are they and any chance of a pic?? Mine was imported with odd wheels (MS01\'s on the front & allycat style deep dish on the rear) think the rears were something insain like 10\'s running 275 35 17. never seen another car with them before or since!!!
Jono
Damn it, was hoping it would be ok!! ;)
Who can get hold of the apexi\'s fairly quickly then? Its a \'95 M reg
cheers
I\'m running some BBS RS 17" wheels, love them - nice offsets and the rears are 9.5" wide ;)
only other pic i\'ve got at the moment...
(http://i12.photobucket.com/albums/a213/Twin40/MyFD8.jpg)
Quote from: Twin40;540483Damn it, was hoping it would be ok!! ;)
Who can get hold of the apexi\'s fairly quickly then? Its a \'95 M reg
cheers
I just recived a early Apexi PFC £480 delivered off ebay :Giggle took about a week to arive from Hongkong
Nice one mate, i\'ve just done an \'impulse buy\'....woo hoo apexi on its way!