Mazda Rotary Club

General => General Technical => Anything Engine/Performance/Tuning related => Topic started by: vitamintommy on September 25, 2008, 05:40:54 AM

Title: modify problem...
Post by: vitamintommy on September 25, 2008, 05:40:54 AM
what i can do to increse hp in rx7 1993 twin turbo ,now i did change a front mount intercooler aluminum radiator,what else i can do?without change to single turbo,if i change to single turbo what i have to buy and change?how about power fc?what is power fc?is that cause u faster?
Title: modify problem...
Post by: SiH on September 25, 2008, 08:01:21 AM
On the stock twins, to get the most out of the car, I\'d go (in the following order):

Cat back exhaust
Air Intake
Power FC
Decat
Frontpipe
Intercooler
Fuel Pump
Larger Injectors

That will see you near the limit of the stock twins - >350bhp at least.

However, After the PFC you will need a remap for most of those mods, so it may be wise to fit them all at once and get it mapped to save getting the map continuously tweaked.
Title: modify problem...
Post by: vitamintommy on September 25, 2008, 02:34:53 PM
Quote from: SiH;540030On the stock twins, to get the most out of the car, I\'d go (in the following order):
 
Cat back exhaust
Air Intake
Power FC
Decat
Frontpipe
Intercooler
Fuel Pump
Larger Injectors
 
That will see you near the limit of the stock twins - >350bhp at least.
 
However, After the PFC you will need a remap for most of those mods, so it may be wise to fit them all at once and get it mapped to save getting the map continuously tweaked.

now have catback exhuast,air intake,intercooler already,what power fc,decat??what size inject i can use?and how much psi fuel pump
Title: modify problem...
Post by: BlitzBoy on September 25, 2008, 02:41:09 PM
Apexi Power FC is the mappable ECU, you will need someone who can map it, try the //www.rx7club.com forum as there are few guys from your country who post on there and do tuning on the rx7