Folks, just wondered what route people had taken when fitting 99 spec bumper light units?
The bulb holders are different to the pre 99 versions. I was considering just chopping the existing connectors off and using spade connectors, but it seems a bit of a bodge.
I also wondered if the little looms for the sidelights use the same main connector over both releases. If they do then I could just buy 99 spec looms to fit them.
So whats everyone else done out there?
When I fitted a 99 spec bumper to my 92 car the light position foul’s the fibre glass inner bumper/crash beam I extended the holes in the inner but you could just cut the ends off completely.
Thanks for the reply, but its the bulb/electrical connection Im intrested in peoples solutions to. Ive removed the bumper bar entirely so Im not struggling for physical room.
FEED do a pre-99 spec lamp convertor loom. I have a brand new one at the moment that im not sure wether im going to use or not.
Quote from: Kevin;534770FEED do a pre-99 spec lamp convertor loom. I have a brand new one at the moment that im not sure wether im going to use or not.
Well if you dont want it, Ill happily buy it. :Thumbs-up
How quick do you need it?
Quote from: Kevin;534799How quick do you need it?
By the end of the week. lol.
As usual Im leaving everything to the last minute and Im trying to get ready for my MOT on monday.
email me: kevin.lockley@flemingsmith.co.uk
and we can discuss price and send if you want.
Email sent.
Hi Andy,
Only got your email after 11pm last night, dont know whats going on with the email system. I\'ve replied to you this morning with my mobile number.