My wiring loom in the pas wheel arch is burning so i think this is y i keep blowing fuse too. I think maybe water has corrodide it because i dont have any wheel arche i got the other side done? any1 changed the loom? how hard is it and how long is the loom, does it run all the way 2 the back does it have any breaks along the way?
err big job....runs all the way round...i think its dash out...and pretty much everything else
o dam, thanks
hmmm - depending on how bad it is, you could do a botchit-n-scarper job by cutting out the affected section, and crimping/soldering on connectors so you can replace just the burnt bits...
no idea how well it would work tho, but if you\'re blowing fuses it might be worth a try?