If anyone has a set of airpump removal blanking plates, would they be kind enough to pop them on a scanner?
A dark background would be good or just leave the scanner lid open.
I\'ll make a black and white image template sheet and post it back on the forum for everyone like me who is too stingy to buy the plates but able to make their own.
Regards,
Martin
can you just use the metal gaskets as the template? I did this for my EGR plate.
Quote from: hairyhoover;525803can you just use the metal gaskets as the template? I did this for my EGR plate.
Thats the logical solution thanks, but it requires the car to be off road while engineering the plates.
The patterns do not seem to be available anywhere, so anyone helping would contribute to the good of the RX7 community (I suppose).
How about a thread with templates for
all the gaskets on the car? Most professionally made ones are a rip-off considering :)
I think this would be a popular start.
I was gona make my own too. Best way i think
I started dismantling the UIM and here is my first attempt for a template of the ACV/EGR blanking plate.
http://www.sparkgap.co.uk/RX7/templates/EGR_ACV.jpg
If you print this then check that no scaling has occured during printing by laying a ruler against my steel ruler image.
There are more to come soon. But please give some feedback or I might lose interest in making more scans public.
Martin
I have no intension of removing my EGR but nice work.
Phil